Buy FastCap 3rd Hand Support System 57-to-144-Inches, 2-pack #3HAND5FastCap 3rd Hand Support System 57-to-144-Inches, 2-pack #3HAND5 Product Description:
- Reaches 5-to 12-feet; Action lever for secure pressure
- Fully articulated ends
- Textured rubber pads for gripping
- Quick release lever
- 2 identical supports included
Customer Reviews
Most helpful customer reviews
67 of 69 people found the following review helpful.
Saved my back!
By Danny Fixit
Got 4 of these units. Have used them for installing kitchen cabinets on two jobs so far. WOW! once you get the hang of adjusting it and getting it in place, they are better than having a work partner. They don't give opinions. They just do their job. The loads I have put on them have been fairly heavy and they still held it using multiple jacks.
Found them very useful too for acting as pushers when installing a deck to push some deck boards into line when they are a bit warped.
Used these jacks as floor to ceiling push clamps during a wood floor installation. After gluing in place the wood flooring, placed a scab 2x6 plank on leading edge of new floor and used these jacks to apply some downward pressure keeping all the installed floor snug and down tight until the adhesive set up. The floor is beautiful.
Expect to also use them soon to hold up a plastic barrier around an area I will be working in order to control dust and dirt migration. Could work very well if you are spray painting indoors.
Always carry at least two of these with me at all times now.
113 of 121 people found the following review helpful.
Details lacking
By AL
For some reason, they do not want to provide many details about this product. So I'll fill in the blanks. The maximum weight limit is 70 pounds. The blue body is made out of steel. The top and bottom plates, and the squeeze handle are made out of plastic. There is a non-marring rubber pad on both the top and bottom plates. The plates swivel on a plastic ball joint. The total shipping weight is 13 pounds. Made in China. Overall I'm quite happy with it. The reason I gave it 4 stars is I'm not sure how long the plastic ball joints are going to last. Time will tell.
35 of 37 people found the following review helpful.
Great tool, poor materials
By Bobb L. Bittner
Problem 1: There is a small plastic bracket that attaches the bottom foot to the steel pole. This bracket was damaged during shipping on both poles. On the one it had shattered in 10 pieces.Solution: I just used epoxy to glue the brackets into the pole.Problem 2: The little spring-loaded nubs that lock the pole open are way too stiff. It actually makes it difficult to adjust the length of the pole, especially when it is in the shortest position and there isn't a good handhold on one end.Solution: I removed the nubs. They were easy to pop out the bottom of the pole (due to the conveniently damaged bottom foot brackets). There is a tension-screw that can also be used to lock the pole open and it works just fine. If you were planning on putting a heavy load on the pole, it would probably be a good idea to put a small bolt through the nub holes, just to make sure the pole doesn't slide closed.Once I got past these problems, the poles actually work really well. They are long, sturdy and easy to adjust. The pole body is steel, so my magnetic laser level will clip right to it. The top foot has a pump mechanism that makes it easy to lock the pole into place between floor and ceiling. The bottom foot has a threaded rod that you can use to easily micro-adjust the height, for hanging cabinets or such.If the pole feet were made out of better materials, this product would easily be a 5-star. The plastic brackets and fittings are very brittle, though, and I doubt that they would survive any serious abuse.
Latest Price: See on Amazon.com!
More Info: See on Amazon.com!
See Customers Review: See on Amazon.com!
